Posted inFoundation Engineering
Soil Profiling With The Cone Penetrometer
Introduction Design of foundations presupposes that the soil conditions (profile and parameters) at the site…
Posted inFoundation Engineering
Characteristic Point
A small diameter footing, of about 1 metre width, can normally be assumed to distribute…
Posted inFoundation Engineering
Newmark Influence Chart
The assumption of ideally elastic response produces an exaggerated radial stress distribution near the location…
Posted inFoundation Engineering
Stress Distribution
Load applied to the surface of a body distributes into the body over a successively…
Posted inFoundation Engineering
Effective Stress
As mentioned, effective stress is the total stress minus the pore pressure (the water pressure…
Posted inFoundation Engineering
Soil Classification by Grain Size
All languages describe "clay", "sand", "gravel", etc., which are terms primarily based on grain size.…
Posted inFoundation Engineering
Classification, Effective Stress, And Stress Distribution
Introduction Before a foundation design can be embarked on, the associated soil profile must be…
Posted inEstimation & Quantity Surveying
Plastering – Things Every Engineer Should Know
PLASTERING plastering The following topics are covered in this post. 1. What is plastering? 2. What are…
Posted inEstimation & Quantity Surveying
Difference between plastering & pointing
Plastering Applying mortar coats on the surfaces of walls, columns, ceiling etc. to get smooth…
Posted inEstimation & Quantity Surveying
How To Minimise The Defects In Plastering Work?
Minimising defects in plastering work Defects in plastering work can be minimised by following the below…